Rocket Boxer 2 Group User Guide & Cleaning
The Boxer is a compact two-group commercial machine with a copper heat-exchanger boiler and automatic dosing from the keypad on each group. Here is how to start it up, make coffee and milk, set your doses and keep it clean.
Which models this covers: The Rocket Boxer 2 Group in stainless, black or white. The steps follow Rocket’s Boxer series user manual, which covers the 1 and 2 group machines, plus Rocket’s Boxer sheet for preinfusion and the group cleaning cycle.
Jump to: Start-up · What the keypad buttons do · Making espresso · Steaming milk and hot water · Setting your coffee and hot water doses · Electronic preinfusion on or off · End of day: water backflush · Weekly: group cleaning cycle with cleaner · Daily and as-needed care · Quick checks before you call us · Water and servicing
Start-up
Installation and plumbing must be done by an authorised technician (we can do this for you). Once it is installed:
- Open the water tap and switch on the power at the wall.
- Turn the on/off switch on the front from 0 to 1. The “machine on” and “boiler filling” lights come on.
- Wait for the “filling” light to go off and the “boiler water level OK” light to come on. The boiler is now full.
- Turn the switch to the next position to switch the heating element on.
- Wait until the boiler pressure reaches working pressure (about 0.9 bar on the 0–3 bar boiler gauge).
- Open the steam valve for a few seconds, then close it. Take care, hot steam comes out. This stops milk being sucked back into the boiler. Wait for the pressure to recover, then you are ready to go.
What the keypad buttons do
- Key 1 (green P): semi-automatic coffee (you start and stop it) and the key you hold when programming.
- Keys 2, 3, 4 and 5: automatic coffee doses (programmable).
- Key 6 (water drop): hot water with automatic dose.
- The small by-pass key lets you run the left-hand group manually, bypassing the electronic control.
Making espresso
- Use the one-cup handle and basket for one cup, or the two-cup handle and basket for two. Rocket’s manual suggests about 7 g of ground coffee per cup (about 14 g for two).
- Dose properly ground coffee into the basket and tamp it.
- Lock the handle firmly into the group and put your cup or cups under the spouts.
- Press the dose key for one or two cups. The machine stops by itself when the programmed amount has run.
- To stop a shot yourself: press key 1 to start, then press any coffee dose key when you have enough.
- Remove the handle and knock out the used grounds.
Steaming milk and hot water
- Milk: fill a clean, cold stainless jug about one third with fresh cold milk. Put the steam wand tip just under the surface, near the centre, and open the steam valve quickly.
- Lift the jug gradually so the tip stays just under the surface while the milk stretches. When you have enough foam, sink the tip to the side and keep heating until the jug is too hot to hold. Rocket says never to heat milk above about 76 °C, as it scalds.
- Close the steam valve quickly, then remove the jug. Always keep the tip under the surface while steam is on, because hot sprays can burn.
- Wipe the wand straight away with a clean damp cloth kept just for the wand. The wand is hot, so don’t touch it with your hand.
- Hot water: hold a food-safe jug under the hot water wand and press key 6. It stops by itself, or press the key again to stop sooner.
Setting your coffee and hot water doses
Set doses with a real handle, basket and ground, tamped coffee, so the volume matches what you actually serve. Rocket suggests using the left-hand keypad. Doses saved there are copied to the same keys on the other group.
- Hold key 1 until its light flashes. That means you are in programming mode. Let go.
- Press the coffee key you want to set (2, 3, 4 or 5). Coffee starts running.
- When the cup has the amount you want, press the same key again to stop. That dose is saved and key 1 starts flashing again.
- Press the next key you want to set within about 4 seconds, or key 1 stops flashing and you are out of programming mode. Repeat for each key.
- Wait about 5 seconds until key 1 stops flashing. You are out of programming mode.
- Hot water dose: this is set on each group separately. Hold key 1 until it flashes, release it, press key 6 and let the water run. Press key 6 again to stop when you have enough. Wait about 5 seconds for key 1 to stop flashing. Hot water doses run on time, so they change a little with boiler pressure.
Electronic preinfusion on or off
Preinfusion is a gentle first wetting of the coffee before full pressure. Use the left-hand group keypad for both steps. Rocket’s sheet for this procedure is older, so if the keys behave differently on your machine, call us on 1300 357 575.
- To turn it on: switch the machine off, then switch it on again while holding key 2 of the left-hand group. The key 2 light comes on.
- Switch the machine off and on again. Electronic preinfusion is now on.
- To turn it off: switch the machine off, then switch it on while holding key 3 of the left-hand group. The key 3 light comes on.
- Switch the machine off and on again. Preinfusion is now off.
End of day: water backflush
Do this with the machine switched on, after each day’s service. The blind basket has no holes, so pressure builds up and the water is very hot. Take care.
- Take the coffee basket out of the handle and fit the blind basket (the one with no holes).
- Lock the handle into the group.
- Press key 1 and stop it after 15 seconds. Fresh water is pushed back through the group and out through the exhaust valve, cleaning it.
- Remove the handle, empty the water from the blind basket and repeat several times until the water you pour out is clean.
Weekly: group cleaning cycle with cleaner
Once a week, backflush with a food-grade espresso machine cleaner. Rocket’s Boxer sheet gives an automatic cycle that takes about 1 minute per group.
- Fit the blind basket into the handle and add the espresso machine cleaner.
- Lock the handle into the group you want to clean.
- Hold key 1 of that group and press key 2.
- The lights on those two keys flash for the whole cycle. When they stop flashing and all lights are on, the cycle is finished. You can stop it any time by pressing another key on that group.
- Take the handle out, rinse it and the blind basket well, then backflush with water only (the end-of-day steps above) until no cleaner foam or smell is left.
- Repeat on the other group, then pull and discard one shot on each group.
Daily and as-needed care
- With the machine switched off, unplugged and fully cool, scrub the shower screens, group gaskets and group flanges with a brush used only for that.
- Wash handles and baskets in warm water with a food-grade espresso machine cleaner. Rocket says to soak them for around 30 minutes in hot water with a capful of cleaner if oils have built up, then rinse in fresh water.
- Clean the drip tray and grid with a non-abrasive damp cloth, and wipe the drain tray under it with a damp cloth and brush.
- Wipe the body of the machine with a soft, non-abrasive cloth. Never use harsh cleaners or scouring powder.
- To pop a basket out, flick it out with a small screwdriver or teaspoon.
Quick checks before you call us
- Doses not saving? You have about 4 seconds between keys, so press the next key to set quickly, then wait 5 seconds at the end.
- Shot not stopping? Press any coffee dose key on that group to stop it.
- Steam feels weak or the machine seems slow to start? Check the boiler gauge. Working pressure is about 0.9 bar.
- Left-hand group not responding to the keypad? The by-pass key runs that group manually.
- Anything else, or if the machine shows a fault, switch it off and call us on 1300 357 575. Repairs and servicing should be done by an authorised technician.
Water and servicing
- Descaling: leave this to us. Your machine should only be descaled by a qualified technician as part of its service. Call 1300 357 575 to book.
- Rocket says the machine must run on clean, soft drinking water, not harder than 7 °F. Use good-quality water.
- Use only original Rocket parts, and have installation and repairs done by an authorised technician.
- Book a service every 12 months for home use, or every 6 months for cafés and busy commercial sites, so seals, gaskets and valves are checked before they wear.
Reorder cleaning supplies
- Cafetto Espresso Cleaner (backflush powder)
- Cafetto EVO organic espresso machine cleaner
- Rhinoware group head brush
Prefer to order by phone? Call us on 1300 357 575.
Official manual and resources
- Rocket Boxer series user manual (Ed. 08.2015): Supplied with the machine; Rocket does not offer a public download on rocket-espresso.com. Misplaced yours? Call us on 1300 357 575 and we’ll help.
- Official YouTube channel: Rocket Espresso
Shop this model
Need a hand?
Call Coffee Machines and Beans on 1300 357 575, or book a service.
1/48 Shandan Circuit, Albion Park Rail NSW 2527
Servicing: home users should have their machine serviced every 12 months; cafés and other busy commercial sites every 6 months.
Written steps are based on Rocket Espresso’s user manuals. Always follow the manual supplied with your machine.
